How the gravel calculator works

Area x depth gives volume; density gives weight. The calculator multiplies length x width x depth to get cubic feet, converts to cubic yards, then multiplies by the density of your gravel type — crushed stone and limestone about 1.4 tons per yard, pea gravel and sand about 1.3, crushed granite about 1.5.

Depth guidance: 3 inches is standard for a driveway, 2 inches for a garden path. Add 5% for compaction and uneven ground. For anything over a cubic yard, bulk delivery is far cheaper per yard than bags.

Laying a garden bed? Try the pea gravel calculator or the mulch calculator.

Worked example: a 20 ft by 10 ft driveway

Take a driveway 20 ft long and 10 ft wide, covered with crushed stone 3 inches deep, with the calculator’s usual 5% waste allowance. Here is the same maths the calculator does, step by step, so you can check its result by hand.

Step 1 – volume in cubic feet. Depth in feet is 3 / 12 = 0.25 ft, so the volume is 20 x 10 x 0.25 = 50 cubic feet.

Step 2 – cubic yards. One cubic yard is 27 cubic feet, so 50 / 27 = 1.85 cubic yards.

Step 3 – waste allowance. The calculator adds the 5% you entered: 1.85 x 1.05 = 1.94 cubic yards to order.

Step 4 – weight in tons. Crushed stone weighs 1.4 tons per cubic yard in this calculator, so 1.94 x 1.4 = 2.72 tons.

Step 5 – bags. Each bag holds 0.5 cubic feet, and the volume with waste is 50 x 1.05 = 52.5 cubic feet, so 52.5 / 0.5 = 105 bags. That is why the calculator’s note says bulk is far cheaper for anything over a cubic yard: 105 bags is a lot of lifting and a lot of plastic. If you enter a price per cubic yard, the bulk cost is simply 1.94 times that price – at $50 per cubic yard, for example, that is $97.20.

Measure twice before you order. Lengths and widths are easy to over- or under-estimate on a driveway that is not a neat rectangle. Measure in two or three places, use the largest length and width, and let the 5% waste allowance cover the uneven spots and the edges that need extra stone. If you change the gravel type, only Step 4 changes: pea gravel and sand use 1.3 tons per cubic yard, crushed granite uses 1.5, and limestone uses 1.4, the same as crushed stone.

How much gravel for a 10 ft wide driveway at 3 inches deep?

The table below uses the same method – volume from length, width and 3 inches of depth, then 1.4 tons per cubic yard for crushed stone – before any waste allowance is added. Add 5% to the cubic yards and the tons if you want the amount to order.

Driveway length Volume Cubic yards Tons (crushed stone)
10 ft 25 cu ft 0.93 1.30
20 ft 50 cu ft 1.85 2.59
30 ft 75 cu ft 2.78 3.89
40 ft 100 cu ft 3.70 5.19

How much gravel for a patio or walkway

A patio or a walkway uses the same calculation as a driveway, only the depth is usually thinner. Two inches is enough for a path or a patio that will carry foot traffic and garden furniture, while a driveway needs 3 inches because cars are heavier. The worked example below uses a 12 ft by 8 ft patio, 2 inches deep, with crushed stone, a 5% waste allowance and a price of $50 per cubic yard, so you can follow every step and check it against the calculator above.

Step 1 – volume in cubic feet. Depth in feet is 2 / 12, so the volume is 12 x 8 x 2 / 12 = 16.00 cubic feet. Step 2 – cubic yards. One cubic yard is 27 cubic feet, so 16.00 / 27 = 0.59 cubic yards. Step 3 – waste allowance. The calculator adds the 5% you entered: 0.59 x 1.05 = 0.62 cubic yards to order. Step 4 – weight in tons. Crushed stone weighs 1.4 tons per cubic yard in this calculator, so 0.62 x 1.4 = 0.87 tons (1,742 lb). Step 5 – bags and cost. The volume with waste is 16.00 x 1.05 = 16.80 cubic feet. Each bag holds 0.5 cubic feet, so 16.80 / 0.5 = 33.6, rounded up to 34 bags, and at $50 per cubic yard the bulk cost is $31.11.

Changing the gravel type changes only the weight, because the volume stays 16.00 cubic feet (0.62 cubic yards with waste). The table below uses the densities in the calculator above – crushed stone and limestone 1.4 tons per cubic yard, pea gravel and sand 1.3, and crushed granite 1.5 – and the calculator returned each weight when the same 12 ft by 8 ft patio was run with that type.

Gravel type Density (tons per cu yd) Weight for this patio (tons)
Crushed stone 1.4 0.87
Pea gravel 1.3 0.81
Crushed granite 1.5 0.93
Limestone 1.4 0.87
Sand 1.3 0.81

For a walkway, measure the length in the same way and use the same 2 inch depth. A narrow path is easy to under-order because the edges spill, so keep the 5% allowance even on a small job, and order bulk rather than bags when the patio is larger than about a cubic yard – 34 bags is already a lot to carry.